ASIA ELEPH registered trademark ASIA ELEPHQuiet · Reliable · Efficient
Home / Products / AEE-G-I · 1250 kW

AEE-G-I · 1250 kW

1250 kW of continuous-duty base load in a single 40 ft high-cube container — 12192 × 2438 × 2896 mm, built for sites where pipeline or field gas is already on hand.

Output 1250 kW Apparent 1563 kVA Noise ≤ 70±1dB(A) @ 7m 40 ft high-cube
AEE-G-I 1250 kW natural-gas power station, front view
Noise @ 7m≤ 70±1dB(A)
DutyContinuous
Footprint12192 × 2438 mm
ProtectionIP44
Gas station customised

A 40 ft high-cube generator set that runs on natural gas.

Where gas is on site, diesel stops being a fuel and starts being a logistics problem — tanker deliveries, bulk storage, spill containment, filter changes and a running cost that moves with the oil price. The AEE-G-I series takes the same welded container architecture as the diesel range and runs it on the gas you already have.

The full 40 ft high-cube envelope gives the gas train, radiator and exhaust treatment the volume they need for genuine continuous duty, and it ships as a standard ISO container — no abnormal-load permit, no special trailer, no customs surprises.

  • Natural gas supply — no diesel storage — runs on pipeline or field gas, with no tanker deliveries and no bulk fuel tank on site.
  • Automatic oil make-up tank — integrated make-up tank covers oil consumption over long runs, so service intervals stretch instead of stopping the plant.
  • Dedicated compartment layout — gas train, radiator and engine bay are thermally separated to hold full rated output at 50°C ambient.
  • Fully welded container, IP44 — container-grade shell for sea freight and salt air, with an optional three-proof package. A preferred choice for natural-gas generation, with a strong cost-to-performance ratio.
Technical data

Specification

Standard configuration. Alternative engines, alternators, voltages and frequencies are configurable per order.

Set weight is a typical value — figures vary with engine and alternator build, and noise is the four-direction average at 75 % load. Tested figures for your exact build are confirmed with the quotation.
ItemValue
SeriesAEE-G-I · natural gas
Rated power1250 kW (1563 kVA)
ApplicationSuper-silent natural-gas power station — continuous duty
EngineWeichai
AlternatorStamford · Leroy-Somer · Mecc Alte · Dingge
Engine speed1500 / 1800 rpm
Rated frequency50 / 60 Hz
Phases3
Three-phase rated voltage380–480 V
Power factor0.8
Frequency droop≤ 3 %
Frequency recovery time≤ 3 s
CoolingDedicated cooling bay; radiator and fan isolated from the engine compartment
Noise level≤ 70±1dB(A) @ 7m
Control systemDigital
Paralleling controllerParalleling controller — brand specified with your order
Internal structureDedicated compartments for gas train, engine and cooling
EnclosureContainer type, fully welded
Dimensions (L × W × H)12192 × 2438 × 2896 mm (40 ft high-cube)
Set weight26000kg
Fuel supplyNatural gas supply — no diesel tank; automatic engine-oil make-up tank
Protection classIP44
Ambient range−10 °C to +50°C (−40 °C with jacket water heater)
Altitude≤ 2000 m
MufflerHospital-grade, impedance-composite
StandardsISO 8528-5:2018 · ISO 8528-10:2022 · GB/T 2820.5:2025 · CE
TransportStandard 40 ft high-cube container — customs freight saving 20 % +
Noise measured as sound pressure level at 7m under ISO 8528 conditions; final tested figure depends on engine and exhaust configuration.
Product highlights

What your operators will notice

Safe — unattended by design

Gas-fed plant with no bulk fuel stored on site: close and lock the door and let it run. All side components sit flush so nothing catches in transit.

Silent — 70±1dB(A) at 7m

Heavy acoustic treatment inside a full-height enclosure and wind-tunnel-inspired muffler technology keep a 1.25MW gas plant within industrial site limits.

Energy saving — compartment design

Gas train, radiator and engine bay are laid out as separate compartments, so cooling air never fights the exhaust heat and the plant holds its rating in summer.

Low failure rate

More than 30 % fewer failures than shaft-driven and conventional structures, thanks to an optimised compartment structure, dual filtration and a simplified cooling drive.

Continuous-duty rating

Engineered for around-the-clock base load: five 250 kW sets run in parallel, with capacity redundancy for long-run cycles. Even if one engine fails, the load keeps running. And when terminal load changes, it starts or stops units on its own.

One-touch operation

One-touch start/stop on the container panel, panel lighting plus internal service lighting for night work, and control redundancy to cut maintenance time. Remote monitoring enables unattended operation.

Typical duty

Where the 1250 kW gas plant works best

Gas fields & pipeline ends

Field gas and pipeline tail-ends turned into saleable power instead of flared or throttled pressure.

Island & weak grids

Base load for island communities and remote grids, paralleled in multiples for redundancy.

Industrial base load

Factories, processing plants and industrial parks running on their own generation.

Data centre prime & standby

Large paralleled blocks for campus-scale loads where gas is already on the utility grid.

Oil & gas installations

Offshore platforms and oilfield camps with HSE-compliant delivery and salt-fog protection.

Crypto-mining power

In certain specific scenarios, natural-gas generation is the first choice for crypto mining. High cost-performance, stable and continuous operation.

Keep comparing

Other power bands

Get the full natural-gas generator set datasheet and the price.

This is a standardised 1250 kW super-silent natural-gas generator set. Tell us the kW, quantity, voltage, gas source and destination port — we reply with drawings, weight, gas consumption figures and a quotation.

Get a Quote Call